Rigging Gear

These are the tower worker's best friend. A lightweight aluminum snaplink, they'll attach to anything - your haul rope, tower brace, etc. and are faster and easier to use than any other method such as a shackle. LOADS ONLY, NOT FOR MAN PROTECTION. $8.00

These are commercial grade nylon slings. They use heavy duty 1" nylon and are rated at 3200# safe working load. Perfect for heavier loads including towers.

This is THE EHS guy wire-puller. It is one of the famous Klein Chicago grips that is used by tower builders and utility companies. It will take wire from 1/8" to 3/8".  $130.00

Used along with carabiners, these very handy lightweight but strong one-inch wide sewn nylon endless straps can be used for rigging loads such as antenna slings, a choker to haul masts up a tower or MANY other tasks. 300 pound safe working load.  $11.00

Measure guy wire tension easily. The PT-1 is spring loaded and hangs onto the guy wire as you adjust it. And it's pretty darned accurate. Measures 3/32 to 5/32 inch cables.  $76.00

Measure guy wire tension easily. The PT-1 is spring loaded and hangs onto the guy wire as you adjust it. And it's pretty darned accurate.Measures 3/16 to 1/4 inch cables.  $95.00

This new product measures bigger wire, 1/4", 9/32", 5/16", and 3/8". It's spring loaded so that it stays on the guy wire while you're adjusting it. $187.00

It attaches to your Tower*Jack or Leg*Aliner and lets you clip it to your climbing belt or haul rope for ease and safety. $15.35

This is the best pulley I've ever used.  Made from high impact plastic so it's pretty lightweight. Top hinges open.  Forged swivel eye.  1000 pound safe working load.  Accepts ropes up to 3/4-inch. $100.00

Made out of canvas, they have snaps that allow them to be attached to virtually any safety belt. Use one on the left for tools and one on the right for parts - these tool bags will save you time and frustration. $18.00

Custom bucket, lightweight and strong. Made out of canvas, has a plastic bottom and polypropylene handle.  For bigger loads, this bucket will hold a typical rotator and measures 12" X 15". With swivel snap. $45.00

Custom bucket, lightweight and strong. Made out of canvas, has a plastic bottom and polypropylene handle.  This bucket measures 8" X 12" and will hold tools, parts, etc. With swivel snap. $40.00

This attaches to your tower leg and gives you a snatch block at the bottom of your tower that takes your vertical pull haul or ginpole rope and lets you pull it horizontally for safer and easier operation. For Rohn 20G, 25G, 45G and 55G.  $115.00